Green Clean Mini Vacuum SLR Sensor Cleaning Kit

*Traveller Kit # SC-4100*

Safe + economical + effective

Digital reflex cameras are continually subjected to problems caused by dust and fluff occurrence. Camera sensors are extremely sensitive and tiny dust particles can cause scratching when mechanically removed with cloths, spatulas or brushes.

MINI VAC removes loose dust and abrasion particles from the sensor and the camera body both contact- and residue-free.

• Safe process due to contact- and residue-free application
• No compression and transportation of dirt particles
• No direct gas contact
• High performance suction action guarantees gentle lifting off of the loose particles, even when confronted with the resistance of the static charging inside the camera
• Economical: In fact the main percentage of contamination is loose and can therefore be removed with the MINI Vacuum
• HI TECH pressurized gas is especially strong, stabile and productive thus resulting in the most economical method of sensor cleaning.
• Effective as the dust is removed from the camera shaft and the objective

PICK-UP drain tube for protection of the sensor

    
This one-way tube was especially designed for use on digital reflex cameras.
The material used is abrasion-free and non-conductive. The end piece of the plastic component has been designed in a trumpet-shaped form and fitted with a crank for better handling. Any unforeseen contact with the sensor leaves no residue, as no softeners are used.

The material is thermo-plastically formed and produced under Clean room requirements. The sterile units are individually packed in order to avoid contamination.

The crank enables an exact positioning of the tube, at the same time leaving the access to the camera shaft free for inspection. Even under static electricity charging even the most resistant particles can be lifted off.

The material used is abrasion-free and non-conductive. The end piece of the plastic component has been designed in a trumpet-shaped form and fitted with a crank for better handling. Any unforeseen contact with the sensor leaves no residue, as no softeners are used.

The material is thermo-plastically formed and produced under Clean room requirements. The sterile units are individually packed in order to avoid contamination.

The crank enables an exact positioning of the tube, at the same time leaving the access to the camera shaft free for inspection. Even under static electricity charging even the most resistant particles can be lifted off.


Keep your DSLR camera clean with MINI Vacuum!

Each Kit Contains:

• 1 x V-3000 MINI VACUUM
   
• 1 x G-2016 HI TECH Air + Vacuum Power 150 ml
   
• 2 x SC-4050 PICK UP protective tubes